After using a period of time, the belt of the elliptical machine is easy to loose and slip during use. This is because the belt is loose, and please restore it according to the following steps:

1、Open the rear cover of the elliptical with a screwdriver.

2、Turn the top wire clockwise with an 8mm hex wrench to tighten the belt, and turn the top wire counterclockwise to loosen the belt.

Note: Tighten the belt here to prevent slipping and fine tuning. If slipping is too serious or the top wire needs to be adjusted for a long distance, please loosen the motor fixing screw and motor adjusting screw first. Adjust the bolt at the above indicated position to the appropriate position.

3、Use the oil gun for oil filling and maintenance for the bearing seat of the elliptical. As indicated by the arrow in the figure, it is suggested to fill the oil to the bearing seat on the left and right sides for maintenance once a month.

4、After using about half a year, some amount of dust may enter the rear cover due to electrostatic friction of the motor. And the users should clean up the dust in time to prevent circuit board short circuit or other mechanical faults caused by excessive dust. Please keep the basic circuit clean.