Spinning Bike Troubleshooting

1. After the bike is used for a period of time, if there is slippage and setback for the pedals movement, the transmission belt may be loose. Please adjust the tightness of the belt. The method is as the following,

    A. First open the diamond-shaped covers on both sides of the bike. (use the cross screwdriver)；

B. Use a 19# open-end wrench to loosen part A on both sides of the bike, use a 14# wrench to loosen the lock nut part B on both sides of the bike, and then use a 6# internal hexagonal wrench to tighten part C on both sides of the bike clockwise at the same time. Turn the screws two laps to see if there is still any slippage. If the slippage disappears, fix the belt and tighten the screws in turn.

2. In the process of use, if you find that the bike body is shaking, please firstly check whether the four adjustable bases are on the same plane or not. If the height of the bases is inconsistent, please adjust it appropriately.

3.After the bike is used for a period of time, if the bicycle has abnormal brake noise or no resistance, it will be necessary to replace the brake felt and refuel. The method is as following：

A. First, lift up the decorative cover of the foot crutch (picture 1), use a 22# sleeve to remove the center axle nut (picture 2), and then use the bike axle tool (picture 3) to remove the foot crutch. After that, remove the shell of the bike with a cross screwdriver (picture 4), and then you will find the brake felt and the refueling part.

B. Replace the brake felt. Use a 10# wrench to remove the brake pressure spring (picture 1), remove the broken brake felt (picture 2) and replace it with a new brake felt (picture 3). It is better to apply a layer of adhesive on the inside of the felt to make it more firm. Finally please install back the brake pressure spring after the replacement.

C. Refuel the flying wheel. Apply evenly some oil on the friction part between the wheel and the felt with a brush, which has rust protection and reduce the damage of the brake felt.

4. The solution to the abnormal noise of the bike:

The bike is a high-speed running equipment, so it is unavoidable that the bearing and other parts lack oil. If the shaft makes abnormal noise during the bike use, please refuel in time. As shown in the picture: the arrow indicates that the joint between the bearing and the central shaft can be dripped with a few drops of lubricating oil. The premise is that the bicycle should be placed in a flat state, which is conducive to the full absorption of the lubricating oil. Wait for five minutes after refueling.

Bike Maintenance Tools

One unit of 22# sleeve, one sets of open end wrench 22-24, 17-19, 13-16, 12-14, 8-10, one unit of 6# internal hexagonal wrench, one unit of screwdriver and one unit of central axis tool. (tips: some tools need to be purchased by yourself)